| 產品編碼 | D-Think_010_PN65N |
| 協議標準 | ISO/IEC 14443A，ISO/IEC 14443 B，ISO/IEC 15693， ISO/IEC 18092，F(xiàn)eliCa，Mifare 1K/4K |
| 工作頻率 | 13.56MHz |
| 識別距離 | 5-8CM |
| 安全模塊 | 有 |
| 供電 | USB供電 |
| 外圍芯片接口 | SWP、NFC‐WI |
| 通訊接口 | UART、I2C、SPI |
| 電氣特性 | 與PN544(PN65N)相一致，見PN544(PN65N)數據手冊 |
| 外型尺寸 | 15*18*1.9mm |
| 工作溫度 | -40 - +65 ℃ |
| 儲存溫度 | -25 - +85 ℃ |
| 引腳號 | 引腳名稱 | 類別 | 描述 | 備注 |
| 1 | GND | Other | Ground | |
| 2 | NC | NC | | |
| 3 | EXT_SW_CTRL | UICC | Control output signal for external UICC power switch | |
| 4 | NC | NC | | |
| 5 | NC | NC | | |
| 6 | NC | NC | | |
| 7 | NC | NC | | |
| 8 | A0/NSS (IF0) | Host | Functionality depends on selected interface | |
| 9 | NC | NC | | |
| 10 | NC | NC | | |
| 11 | NC | NC | | |
| 12 | NC | NC | | |
| 13 | NC | NC | | |
| 14 | IFSEL2 | Configuration | Host interface select input 2 | |
| 15 | IFSEL1 | Configuration | Host interface select input 1 | |
| 16 | RST_N | SE | RST pin of ISO IEC 7816 interface of SmartMX | 僅PN65N |
| 17 | VMID | Antenna | Contactless receiver Voltage reference | |
| 18 | RX | Antenna | Contactless Receiver input | |
| 19 | PF1 | Antenna | Antenna connection for card emulation | |
| 20 | NC | NC | | |
| 21 | TX1 | Antenna | Contactless Transmitter output 1 | |
| 22 | TX2 | Antenna | Contactless Transmitter output 2 | |
| 23 | PF2 | Antenna | Antenna connection for card emulation | |
| 24 | GND | Other | Ground | |
| 25 | NC | NC | | |
| 26 | SIGIN | SE | NFC-WI data input | |
| 27 | VEN_MON (LX) | Other | DCDC coil | PN544 |
| Enable of the battery voltage monitor | PN65N | |||
| 28 | I/O1 | SE | IO pin of ISO IEC 7816 interface of SmartMX | 僅PN65N |
| 29 | VBAT | Power | Battery voltage | |
| 30 | SIGOUT | SE | NFC-WI data output | |
| 31 | SVDD | SE | SmartMX power,fixed to 1.8V | |
| 32 | SWP | UICC | SWP data connection | |
| 33 | SIMVCC | UICC | Power output to supply the UICC | |
| 34 | VEN | Host | Enable/disable LDO regulator | |
| 35 | PMUVCC | Host | UICC Power in from mobile PMU | |
| 36 | CLK | SE | CLK pin of ISO IEC 7816 interface of SmartMX | 僅PN65N |
| 37 | NRESET | Host | PN544有用，PN65N中接PVDD | |
| 38 | NC | NC | | |
| 39 | SDA/SCK (IF2) | Host | Functionality depends on selected interface | |
| 40 | PVDD | Host | Pad supply voltage Input(VI/O) | |
| 41 | RXD/A1/MOSI (IF1) | Host | Functionality depends on selected interface | |
| 42 | IRQ | Host | IRQ output | |
| 43 | TXD/SCL/MISO (IF3) | Host | Functionality depends on selected interface | |
| 44 | IFSEL0 | Configuration | Host interface select input 0 | |
| 45 | GPIO5 | GPIO | Run mode selection | 僅PN65N |
| 46 | GPIO4 | GPIO | Download mode control | 僅PN65N |
| 類別 | 引腳名稱 | 引腳號 | 描述 | 備注 |
| Host connection pins | VEN | 34 | Enable/disable LDO regulator | |
| PVDD | 40 | Pad supply voltageInput(VI/O) | | |
| PMUVCC | 35 | UICC Power in from mobile PMU | | |
| IRQ | 42 | IRQ output | | |
| TXD/SCL/MISO (IF3) | 43 | Functionality depends on selected interface | | |
| SDA/SCK (IF2) | 39 | Functionality depends on selected interface | | |
| RXD/A1/MOSI (IF1) | 41 | Functionality depends on selected interface | | |
| A0/NSS (IF0) | 8 | Functionality depends on selected interface | | |
| NRESET | 37 | PN544有用，PN65N中接PVDD | | |
| UICC connection pins | SIMVCC | 33 | Power output to supply the UICC | |
| SWP | 32 | SWP data connection | | |
| EXT_SW_CTRL | 3 | Control output signal for external UICC power switch | | |
| SE connection pins | SVDD | 31 | SmartMX power,fixed to 1.8V | |
| SIGIN | 26 | NFC-WI data input | | |
| SIGOUT | 30 | NFC-WI data output | | |
| CLK | 36 | CLK pin of ISO IEC 7816 interface of SmartMX | 僅PN65N | |
| I/O1 | 28 | IO pin of ISO IEC 7816 interface of SmartMX | 僅PN65N | |
| RST_N | 16 | RST pin of ISO IEC 7816 interface of SmartMX | 僅PN65N | |
| Antenna connection pins | TX1 | 21 | Contactless Transmitter output1 | |
| TX2 | 22 | Contactless Transmitter output2 | | |
| RX | 18 | Contactless Receiver input | | |
| VMID | 17 | Contactless receiver Voltage reference | | |
| PF1 | 19 | Antenna connection for card emulation | | |
| PF2 | 23 | Antenna connection for card emulation | | |
| GPIO pins | GPIO4 | 46 | Download mode control | 僅PN65N |
| GPIO5 | 45 | Run mode selection | 僅PN65N | |
| Configuration pins | IFSEL0 | 44 | Host interface select input 0 | |
| IFSEL1 | 15 | Host interface select input 1 | | |
| IFSEL2 | 14 | Host interface select input 2 | | |
| Other pins | VBAT | 29 | Battery voltage | |
| GND | 1 | Ground | | |
| GND | 24 | Ground | | |
| VEN_MON (LX) | 27 | DCDC coil | PN544 | |
| Enable of the battery voltage monitor | PN65N | |||
| NC | NC | 2 | | |
| 4 | | | ||
| 5 | | | ||
| 6 | | | ||
| 7 | | | ||
| 9 | | | ||
| 10 | | | ||
| 11 | | | ||
| 12 | | | ||
| 13 | | | ||
| 20 | | | ||
| 25 | | | ||
| 38 | | |
| 歡迎光臨 D-Think | 東遠科技-廣州東遠智能科技有限公司- (http://www.pjkb.com.cn/) | Powered by Discuz! X3.4 |